Path: utzoo!mnetor!uunet!husc6!ukma!tut.cis.ohio-state.edu!osu-cis!bcd-dyn!dsacg1!nts0699
From: nts0699@dsacg1.UUCP (Gene McManus)
Newsgroups: comp.sys.ibm.pc
Subject: Installing Seagate ST421 in PC clone
Message-ID: <412@dsacg1.UUCP>
Date: 11 Apr 88 13:04:06 GMT
Organization: Defense Logistics Agency Systems Automation Center, Columbus
Lines: 22
Keywords: hard disk st421

I have come across an old Seagate ST421 10MB drive that I would like to
install in my Brand-Z PC clone, which currently has a 20MB half-height
hard drive. I'm looking for some general installation info on the drive,
since I don't have a manual. Drive was removed from an out-of-service
DEC Rainbow 100B.

Does someone out there know the correct dip jumper setup (on the on-board
controller) for this to be a second drive in a PC? There is currently one
trace in the dip jumper cut. Drive will be used with a Western Digital
controller. Any special problems to be aware of when doing a low-level
format, etc?

Also, am I correct in assuming that I'll need a 'double-header' control
cable as well as a second data cable?

Thanx for your advice
Gene
-- 
Gene McManus @ Defense Logistics Agency Systems Automation Center,
	       Columbus, OH 43215 (614) 238-9403,    Autovon 850-
UUCP:		{uunet!gould,cbosgd!osu-cis}!dsacg1!gmcmanus
The views expressed are my own, not those of The Agency, or Dept. of Defense