Path: utzoo!mnetor!uunet!lll-winken!lll-lcc!ames!mailrus!tut.cis.ohio-state.edu!bloom-beacon!mit-eddie!bbn!rochester!kodak!dennett
From: dennett@kodak.UUCP (Charlie Dennett)
Newsgroups: comp.sys.hp
Subject: Re: Traps
Message-ID: <1229@kodak.UUCP>
Date: 23 Apr 88 12:42:36 GMT
References: <4654@cup.portal.com>
Reply-To: dennett@kodak.UUCP (charlie dennett)
Distribution: na
Organization: Eastman Kodak Co, Rochester, NY
Lines: 18

In article <4654@cup.portal.com> Mike_W_Ryan@cup.portal.com writes:
>Does anyone know of how to utilize control Y traps in PASCAL3000? 

I happen to have a copy of the MPE V Intrinsics manual in front of me.
It contains a few intrinsics dealing with traps.  I think it has the one
you need.  XCONTRAP enables or disables the CONTROL-Y trap.  It describes 
the parameters needed to call the intrinsic and also refers the reader to
Section 5 of the Intrinsics Manual.  All traps are discussed in pages 5-37
through 5-49 with control-Y traps discussed on page 5-46.  There is also a 
small sample SPL program using the Control-Y trap.

Be aware - I have never used what I described above.  This might be way
out in left field. If you get it to work, I'd be curious to hear about it.

-- 
Charlie Dennett       | UUCP: ...!rutgers!rochester!kodak!dennett
Eastman Kodak Company | Voice: 716-726-4480
901 Elmgrove Road     | Company Mail: Dept 420 Tech. Support B-2/F-1        
Rochester, NY 14650   | Company DECnet: VXMM07::DENNETT