Path: utzoo!mnetor!uunet!husc6!linus!security!rpg
From: rpg@security.uucp (Robert P. Goldsmith)
Newsgroups: comp.sys.ibm.pc
Subject: Re: VGA board <-> Multiscan Monitor Cable Adapters
Message-ID: <29877@linus.UUCP>
Date: 21 Apr 88 15:46:44 GMT
References: <29873@linus.UUCP>
Sender: news@linus.UUCP
Reply-To: rpg@security.UUCP (Robert P. Goldsmith)
Organization: The MITRE Corporation, Bedford MA
Lines: 28

There is an error in the Pin assignment table I gave.  Pin 9 on the
monitor input splits to both pins 10 and 11 at the board.  The correct
assignments are given below.  Sorry for the error.


			VGA - Monitor Pin Assignments

					Taxan	
			VGA	Monitor Monitor 
Function		Pin	Pin	Function (Analog Signal)
--------		---	---	-----------
Red Video		1	1	Red Video
Green Video		2	2	Green Video
Blue Video		3	3	Blue Video
Monitor Id Bit 2	4	
- not used -		5	
Red Ground		6	6 	Red Ground
Green Ground		7	7 	Green Ground
Blue Ground		8	8 	Blue Ground
Key (no pin)		9	
Synch Ground		10	9 	Synch Ground
Monitor Id Bit 0	11      9
Monitor Id Bit 1	12
Horizontal Synch	13	4	Hor/Vert Synch
Vertical Synch		14	5	Mode Select	
- not used -		15

On the NEC adapter, pins 4 and  are reversed.