Path: utzoo!mnetor!uunet!husc6!mailrus!tut.cis.ohio-state.edu!bloom-beacon!gatech!purdue!decwrl!hplabs!hpda!hpcupt1!hpcuhb!hpscdc!davea
From: davea@hpscdc.HP.COM (Dave Angelini)
Newsgroups: sci.electronics
Subject: Re: internal breakdown (?) in caps or transistors
Message-ID: <5770003@hpscdc.HP.COM>
Date: 28 Apr 88 14:35:50 GMT
References: <20743@oliveb.olivetti.com>
Organization: HP, Santa Clara, CA
Lines: 6

Check the low value resistors on that channels out stage. change all lytics,
check and bias stage,now check all resistors, at this stage I would probably
scrap it because you probably have a active device or a solder joint breaking
down. there is more you can do but is this unit "special".

                                                      Dave