Path: utzoo!utgpu!water!watmath!clyde!att!osu-cis!tut.cis.ohio-state.edu!bloom-beacon!gatech!purdue!i.cc.purdue.edu!j.cc.purdue.edu!pur-ee!uiucdcs!uiucdcsp!spalding
From: spalding@uiucdcsp.cs.uiuc.edu
Newsgroups: comp.sys.intel
Subject: iPDS EMV51A Emulation Vehicle
Message-ID: <80000005@uiucdcsp>
Date: 28 May 88 22:59:00 GMT
Lines: 11
Nf-ID: #N:uiucdcsp:80000005:000:430
Nf-From: uiucdcsp.cs.uiuc.edu!spalding    May 28 17:59:00 1988


Running the MCS-51 Emulation Vehicle on the iPDS, how do I
refer to PL/M-51 line numbers to set breakpoints etc.  The PL/M-51
documentation says I can do this, but the EMV51A documentation
doesn't say how.  I'm getting the symbols (procedure names, labels)
ok.  I just need an example of the syntax for specifying line numbers in
EMV51A commands.  BTW, this is EMV51A version 1.2.

Thanks,
John W. Spalding
spalding@p.cs.uiuc.edu