Path: utzoo!utgpu!water!watmath!clyde!att!osu-cis!tut.cis.ohio-state.edu!mailrus!ames!eos!riacs!julian
From: julian@riacs.edu (Julian E Gomez)
Newsgroups: comp.sys.mac.hypercard
Subject: Re: Animate?
Keywords: animation, Hypercard
Message-ID: <813@hydra.riacs.edu>
Date: 29 May 88 04:23:34 GMT
References: <1939@ssc-vax.UUCP>
Reply-To: julian@hydra.riacs.edu.UUCP (Julian E Gomez)
Organization: Research Institute for Advanced Computer Science
Lines: 15

In article <1939@ssc-vax.UUCP> bmm@ssc-vax.UUCP (Bruce Mansfield) writes:
" What is the recommended method for animating in hypercard.  I tried
" going to successive cards in a stack, waiting a few ticks at each
" card, starting from the openCard handler of the first card.  After about 6
" cards, however, I get the error "Too Much Recursion".  Why do I get
" this error and what does it mean?

Wouldn't it be easier (admittedly more expensive) to use
the VideoWorks HyperCard driver?

-- 
"Have you ever wondered if taxation without representation was cheaper?"

	Julian "Dr. Wombat" Gomez
	julian@riacs.edu || {...decvax!}ames!riacs!julian