Path: utzoo!utgpu!water!watmath!clyde!att!pacbell!ames!mailrus!tut.cis.ohio-state.edu!ukma!psuvm.bitnet!cunyvm!ndsuvm1.bitnet!nu013809
From: NU013809@NDSUVM1.BITNET (Greg Wettstein)
Newsgroups: comp.binaries.ibm.pc.d
Subject: Re: That morse program
Message-ID: <1225NU013809@NDSUVM1>
Date: 9 Jun 88 12:46:46 GMT
References: <3085@crash.cts.com> <1860@hubcap.UUCP>
Organization: North Dakota Higher Education Computer Network, Fargo, ND
Lines: 15
DISCLAIMER: Author bears full responsibility for contents of this article.

I downloaded the morse code program and tried to run it on our PS/2
Model 60 under DOS 3.3 and all I get is the error message stating that
all files must be in the same directory as the executable.  I have a
70 Meg. hard disk brocken down into three partitions plus a 1 meg ram disk.
The program will not function on any of these four disks.  I also created
subdirectories of varying titles on each of the four disk and tried
executing the program from there, still no success.  The program author
comments in the documentation that the previous version of the program
needed to be run from a specific directory.  I am wondering if an older
version of the program was mistakenly packaged rather than the new
one.  Comments??

                                  As always,
                                  G.W. Wettstein
                                  WB0YVX/NU013809@NDSUVM1