Path: utzoo!utgpu!water!watmath!clyde!att!pacbell!ames!pasteur!ucbvax!decwrl!purdue!gatech!psuvax1!psuhcx!wcf From: wcf@psuhcx.psu.edu (Bill Fenner) Newsgroups: comp.binaries.ibm.pc.d Subject: Re: Zmodem Keywords: Zmodem Unix DSZ Zcomm Sz Rz Errors Ack! Pft! Message-ID: <145@psuhcx.psu.edu> Date: 10 Jun 88 18:43:13 GMT References: <3079@crash.cts.com> <9599@e.ms.uky.edu> <22019@amdcad.AMD.COM> Reply-To: wcf@psuhcx (Bill Fenner) Organization: Penn State University Lines: 21 In article <22019@amdcad.AMD.COM> indra@amdcad.UUCP (Indra K. Singhal) writes: |In article <9599@e.ms.uky.edu> simon@ms.uky.edu (Simon Gales) writes: |> Does anyone out there |> have a working copy of both dsz & Unix sz/rz that are known to work |> well together? A copy of both would be greatly appreciated. |> |I compiled sz/rz on UNIX and found when ever I use it, I repeatedly get |CRC (or bad block) errors at 3072 bytes and multiples of 3K. I could not |explain it and have suspended using it. | |This happened with ZCOMM on the PC and also occurs with GT PowerComm. |Explanations anyone ? No explanation here... My DSZ and sz/rz pair work just fine. I think the sz/rz are REALLY old... I just found them in a misc directory and decided to compile them... but they work great, with BinkleyTerm and with DSZ. -- __ _ _ _____ Bill Fenner Bitnet: wcf @ psuhcx.bitnet / ) // // / ' Internet: wcf @ hcx.psu.edu /--< o // // ,-/-, _ __ __ _ __ UUCP: ihnp4!psuvax1!psuhcx!wcf /___/_<_