Path: utzoo!utgpu!water!watmath!clyde!att!osu-cis!tut.cis.ohio-state.edu!bloom-beacon!bu-cs!purdue!decwrl!sun!aeras!grinch!luis
From: luis@grinch.UUCP (luis)
Newsgroups: comp.sys.ibm.pc
Subject: Faster Serial Ports... How can I?
Keywords: Serial Ports, Speed, 19.2k
Message-ID: <302@grinch.grinch.UUCP>
Date: 30 May 88 20:39:21 GMT
Organization: Textural Software, San Jose, Ca
Lines: 19

I recently purchased a TELEBIT Trailblazer Plus, and am using it on my
AT Clone until I can get my Unix system.  After getting the modem, I noticed
that my communications package, GT-COMM (Ver. 12.10), only supported up
to 9600 baud, and was told my someone that DOS could only handle up to
9600 Baud..  I hate having a modem that has to wait for my system when
I logon at 19.2k!!  So, does anyone have any ideas on how to get around
the 'problem'?  Is there a software package out that supports 19.2k on an
AT?  For that matter, will the AT even support 19.2k?

Any help is highly appreciated!!  Please reply via E-mail, since I usually
don't have time to read all the messages in comp.sys.ibm.pc... Thank You..

-------------------------------------------------------------------------------
Luis Chanu  /  Awesome Possum         "Live every day as if it were your last,
                                         because one day you will be right."
UUCP: ...ihnp4!sun!aeras!grinch!luis                            -Benny Hill
UUCP: ...pyramid!wjvax!grinch!luis
              Disk-Claimer: That's not your disk, that's my disk.
-------------------------------------------------------------------------------