Path: utzoo!utgpu!water!watmath!clyde!att!osu-cis!tut.cis.ohio-state.edu!mailrus!ames!ncar!noao!mcdsun!sleazy!Heflich
From: Heflich@sleazy.UUCP (Alan Heflich)
Newsgroups: comp.sys.mac
Subject: Re: Problems with System 6.0?????
Message-ID: <971@sleazy.UUCP>
Date: 8 Jun 88 16:52:51 GMT
References: <3066@polyslo.UUCP> <1151@ndmath.UUCP>
Reply-To: Heflich@sleazy.UUCP (Alan Heflich)
Organization: Motorola GEG, Scottsdale, Az
Lines: 28

In article <1151@ndmath.UUCP> snow@ndmath.UUCP (Dennis Snow) writes:
>In article <3066@polyslo.UUCP>, dorourke@polyslo.UUCP (David O'Rourke) writes:
>> 
>>   I just installed System 6.0 on my Hard Drive.  Looked good at first but
>> I think I've found a problem.
>> 
>>   SmartCom II version 3.0a, VersaPro, and Red Ryder all hang when trying to
>> dial the phone.  The system just hangs, no if's ands or buts.  Is this my
>
>I found another critical problem with System 6.0 on my vanilla Mac + :
>Dark Castle won't run :-). It complains about the high memory configuration. 
>
>Dennis Snow			snow@ndmath.math.notredame.edu

Well I have Sys 6.0 on my hard drive.  Red Ryder runs fine...of course I give 
it a partition (under Multifinder) of 750K so I can save lots of screens some-
where between 75 and 100).

I don't run Dark Castleeither but I would be careful if Mac Pluses are
upgraded with anything other than standard SIMMs.

The only problem I have with Sys 6.0 is with 4-D.  ACIUS acknowleges the
problem and promises to have a fix out soon.

Alan Heflich

Internet:   Heflich @ Dockmaster.arpa
Usenet:     {backbone}!nud!sleazy!heflich