Path: utzoo!utgpu!water!watmath!clyde!att!osu-cis!tut.cis.ohio-state.edu!bloom-beacon!bu-cs!purdue!decwrl!decvax!tektronix!reed!nscpdc!joer
From: joer@nscpdc.NSC.COM (Joe Rawlings    )
Newsgroups: comp.sys.nsc.32k
Subject: Re: System V.2 TTY device driver?
Keywords: V.2 device driver
Message-ID: <1208@nscpdc.NSC.COM>
Date: 8 Jun 88 16:53:37 GMT
References: <459@daver.UUCP> <470@daver.UUCP>
Reply-To: joer@nscpdc.UUCP (Joe Rawlings    )
Organization: NSC Portland Development Center
Lines: 24

>In article <459@daver.UUCP> daver@daver.UUCP (Dave Rand) writes:
>I have been trying to repair the current device driver for the
>ICM-3216, but just cannot seem to get the last bugs out of it.
>(The obvious ones were T_BLOCK and T_UNBLOCK not working!)

After talking with Dave via normal email, I discovered that he
is running with down revision software.  These bugs were fixed
in last summer's maintenance release.  The maintenance release
also fixed numerous other problems and is well worth the $100.00 
upgrade cost.  The upgrade also comes with new PROMs which are 
also vastly improved.

To order the latest revsion (H), of the SVR2 software, please
contact Jim Hervey at (408) 562-4713.

I would like to thank Dave publicaly for his concern and for his
willingness to share his hard work.

JR

-- 
******************************************************************************* *  Joe Rawlings                         nsc!nscpdc!joer                       * 
*  ICM Product Support                  1-800-222-2433 (outside Oregon)       * 
*  Portland Development Center          (503)-629-4414 (Oregon/World)         * *******************************************************************************