Newsgroups: comp.sys.m6809
Path: utzoo!lsuc!jimomura
From: jimomura@lsuc.uucp (Jim Omura)
Subject: CoCo3 Windows, Graphic Cursor
Keywords: 
Followup-To: 
Reply-To: jimomura@lsuc.UUCP (Jim Omura)
Date: Thu, 16-Jun-88 01:25:08 EDT
Summary: Display offsets
Message-ID: <1988Jun16.012510.27650@lsuc.uucp>
Distribution: na
Expires: 
Sender: 
References: 
Organization: Consultant, Toronto


     With my current project rolling along I've come to another
problem.  I think there is a solution, but I can't find anything
in the manuals:

     I'm using 8 * 8 and 16 * 16 cursors where the center point
is the "hot spot" rather than the upper left corner.  Now, the
standard cursor set has a cross-hair, so it's clearly something
they knew people would be doing.  Is there some system call I
can use to tell the system to display the cursor at an offset
of -3 * -3 or -7 * -7 (X * Y)?  If not, I could work out a
kludge on the application level, but it's not something I'd
like to have on the application level.

Cheers! -- Jim O.
-- 
Jim Omura, 2A King George's Drive, Toronto, (416) 652-3880
ihnp4!utzoo!lsuc!jimomura
Byte Information eXchange: jimomura