Path: utzoo!attcan!uunet!husc6!think!ames!pasteur!agate!ig!uwmcsd1!lakesys!macak
From: macak@lakesys.UUCP (Jim Macak)
Newsgroups: comp.sys.mac
Subject: Re: I just thrashed my Hard Disk!
Message-ID: <748@lakesys.UUCP>
Date: 17 Jun 88 16:45:00 GMT
References: <3599@okstate.UUCP> <76000227@uiucdcsp> <8918@dartvax.Dartmouth.EDU> <602@osupyr.mast.ohio-state.edu>
Reply-To: macak@lakesys.UUCP (Jim Macak)
Distribution: na
Organization: Lake Systems - Milwaukee, WI
Lines: 22

In article <602@osupyr.mast.ohio-state.edu> pgn@osupyr.mast.ohio-state.edu.UUCP (Paul G. Nevai) writes:
>
>I know there is a key combination which let's one observe what Disk Firts Aid
>is doing. I forgot it. Any help?

Once you open Disk First Aid, just hit command-S and you will see an
additional window that will report the progress of the checking that Disk
First Aid goes through, and also gives a report that the repair has been
completed.

I wish this window would give more specific info about the problems that were
found, though.  I think it would be interesting to see if the things that need
repair are consistent or if new problems are always cropping up.

Jim


-- 

>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<
Jim -->  macak@lakesys.UUCP (Jim Macak)  {Standard disclaimer, nothin' fancy!}
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>><<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<<