Xref: utzoo comp.protocols.tcp-ip.ibmpc:689 comp.sys.sequent:45 comp.dcom.lans:1643
Path: utzoo!utgpu!water!watmath!clyde!bellcore!rutgers!ucsd!nosc!helios.ee.lbl.gov!pasteur!ames!amdahl!pacbell!pbseps!rdp
From: rdp@pbseps.UUCP (Richard Perlman)
Newsgroups: comp.protocols.tcp-ip.ibmpc,comp.sys.sequent,comp.dcom.lans
Subject: Ether terminal software (PC)
Message-ID: <137@pbseps.UUCP>
Date: 1 Aug 88 15:42:28 GMT
Reply-To: rdp@pbseps.PacBell.COM (Richard Perlman)
Organization: Pacific Bell Separations, San Francisco, CA
Lines: 20


We are looking for an MS-DOS terminal program to allow PCs to
access a TCP/IP host over ethernet.  We are not looking for file
sharing (we will be using PC-NFS where that is required).  All
that is required is the ability to set-up a terminal session
(preferable with vt-100 emulation)

Our installation is comprised of the following:
	Sequent Symmetry (4 processors)
	IBM-XT & Compatible (a few ATs) PCs with WD8003E Ether Boards
	Cheapernet (Thin-wire)

Advance apologies if I have missed a recent dicussion on this
topic.  If that is the case, could someone forward the relevent
postings to me.


-- 
Richard Perlman * pbseps!rdp@PacBell.COM || {ames,sun,att}!pacbell!pbseps!rdp
180 New Montgomery St. rm 602,  San Francisco, CA  94105  |*|  (415) 545-0233