Xref: utzoo comp.sys.amiga:21128 comp.sys.amiga.tech:1279
Path: utzoo!attcan!uunet!cbmvax!carolyn
From: carolyn@cbmvax.UUCP (Carolyn Scheppner CATS)
Newsgroups: comp.sys.amiga,comp.sys.amiga.tech
Subject: Re: using the interface between an Amiga 2000 and bridgecard
Message-ID: <4288@cbmvax.UUCP>
Date: 19 Jul 88 19:33:12 GMT
References: <5217@watcgl.waterloo.edu>
Reply-To: carolyn@cbmvax.UUCP (Carolyn Scheppner CATS)
Distribution: comp
Organization: Commodore Technology, West Chester, PA
Lines: 18

In article <5217@watcgl.waterloo.edu> grwalter@watcgl.waterloo.edu (Fred Walter) writes:
>
>Also, in the Introduction to the Amiga 2000 manual it mentions a jumper
>J301 which is used to enable/disable (or something like that) a second
>internal drive. Where is this jumper found on a Rev 4.3 B2000 ? 

On my B2000 it was just under the where the floppy data cable connects
to the motherboard (it comes out from under the power supply tray on
the left side).  You must jumper it if you hook up a second internal
floppy.

-- 
==========================================================================
  Carolyn Scheppner -- CATS  Commodore Amiga Technical Support
  PHONE 215-431-9180   UUCP  ...{uunet,allegra,rutgers}!cbmvax!carolyn 

 Calm down.  It's just ones and zeros.
==========================================================================