Path: utzoo!utgpu!water!watmath!clyde!att!ucbvax!ucdavis!caldwr!kwongj
From: kwongj@caldwr.caldwr.gov (James Kwong)
Newsgroups: comp.sys.apollo
Subject: Re: TCP/IP 3.1 hangs on rsh
Summary: try shutting down the machine after installation
Message-ID: <362@caldwr.caldwr.gov>
Date: 21 Jul 88 16:06:03 GMT
References: <5400029@iuvax> <1894@stpstn.UUCP>
Organization: California Department of Water Resources
Lines: 20

In article <1894@stpstn.UUCP>, aad@stpstn.UUCP (Anthony A. Datri) writes:
> 
> I'd be happy if I could get 3.1 tcp to work at all.   I install it,
> and get some error about the /lib/streams file being out of date, so
> I install it with the /lib/streams off of the 3.1 tcp tape, and get
> the same error.-- 

Did you try shutting down the machine after you installed the new
tcp stuff? I had a similar problem when i installed it over a modem.
I couldn't shut it down after the installation and try to restart tcp
my hand with no luck. it keep complaining about the stream being out
of date. after I rebooted the machine everything was fine. Hope this
helps.

JK

-- 
James Kwong  Calif. Depart. of H2O Resources, Sacramento, CA 95802
caldwr!kwongj@ucdavis.edu(Internet) ...!ucbvax!ucdavis!caldwr!kwongj (UUCP)
The opinions expressed above are mine, not those of the State of California or the California Department of Water Resources.