Path: utzoo!attcan!uunet!husc6!think!ames!zodiac!jdevries
From: jdevries@zodiac.ads.com (Jeff De Vries)
Newsgroups: comp.sys.att
Subject: Two questions
Message-ID: <4980@zodiac.UUCP>
Date: 25 Jul 88 20:03:06 GMT
Sender: news@zodiac.UUCP
Reply-To: jdevries@ads.com (Jeff De Vries)
Distribution: na
Organization: Advanced Decision Systems, Mt. View, CA (415) 960-7300
Lines: 17

I have a couple of questions I'm hoping someone might know the answer to:

1) If you put a printer on the serial port, does the 7300 use hardware
or software flow control.  I am running 3.51.  If it uses hardware flow
control, which line is it expecting the info on? (DSR, DCD, CTS ???)

2) I brought up GNU Emacs 18.51 on the 7300 using TERMCAP, but I can't
seem to get it to load using TERMINFO.  I have TERMINFO installed on the
7300.  Loader complains about not finding several of the routines in 
curses, i.e. tparm etc.  I am using -lcurses, as per the 7300 manual on
TERMINFO.  If I try to specify both -lcurses -ltermcap I get errors about
PC being multiply defined with different sizes.  What am I not doing right?

Thanks!
Jeff De Vries
jdevries@ads.com (ARPA)
/* usual disclaimer */