Path: utzoo!utgpu!attcan!uunet!husc6!rutgers!gatech!psuvax1!vu-vlsi!dsinc!syd
From: syd@dsinc.UUCP (Syd Weinstein)
Newsgroups: comp.databases
Subject: Re: Accell 1.2 vs 1.3 weirdness
Keywords: accell unify 1.2 1.3
Message-ID: <424@dsinc.UUCP>
Date: 3 Aug 88 02:15:52 GMT
References: <301@hrc.UUCP>
Reply-To: syd@dsinc.UUCP (Syd Weinstein)
Organization: Datacomp Systems, Inc., Huntingdon Valley, PA 19006
Lines: 24

In article <301@hrc.UUCP> dan@hrc.UUCP (Dan Troxel VP) writes:
:I am currently running Accell 1.3 over Unify 4.0 . Is the following 
:supposed to happen:
:	Going into the Accell menu, (Unify side of it), if I had
:	constructed the database under 1.2, the menu title on top
:	of the page reads "Accell 1.2". If I create a new database
:	under 1.3, it reads "Accell 1.3". The 1.2 version has been
:	reconstructed to run under 1.3 .
:Is this supposed to occur? If so, is there a reason? Will the 1.2 type, be
:different in any way compared to the 1.3 type???
:

Yes, all is ok.

In fact, what actually happens is that Unify updated the database
from accell 1.2 to accell 1.3, but it didn't change the system header,
as perhaps you already had.  This header is on the screen parmnt.
You can change it yourself to anything you want.

-- 
=====================================================================
Sydney S. Weinstein, CDP, CCP
Datacomp Systems, Inc.				Voice: (215) 947-9900
{allegra,bellcore,bpa,vu-vlsi}!dsinc!syd	FAX:   (215) 938-0235