Path: utzoo!utgpu!attcan!uunet!wyse!vsi1!ames!necntc!dandelion!ulowell!bu-tyng!draper From: draper@bu-tyng.bu.edu (dday) Newsgroups: comp.sys.ibm.pc Subject: Seek errors on ST-225. HELP!!!! Message-ID: <1650@bu-tyng.bu.edu> Date: 3 Aug 88 21:27:37 GMT Reply-To: draper@bu-tyng.UUCP (dday) Organization: Boston University, Tyngsboro MA Lines: 38 I am having seek problems with a Seagate ST-225 drive using a Winchestor WD1002S-WX2 controller card. The machine is a Fountain XT clone with the hard drive added after purchase. Symptoms: Turn machine on. Sometimes it boots, sometines it dosen't. (from the hard drive, always boots from floppy) After the machine is booted trying to do just about anything that requires a hard drive access causes the drive light to turn on, the drive can be heard stepping or "clicking" as it tries to read the disk. This continues for about 15 to 20 seconds. It then prompts you with a seek error message and the dos prompt to abort, ignore, fail or retry. Disk accesses are successful about 20% of the time. I have tried running DOS chkdsk and Norton disk test. Neither of them will even run. The machine gets seek errors almost immediatly. This machine is approx. 2 years old ... but it has MINIMAL run time on it. I don't know if this has anything to do with it but the machine hadn't been used in over 2 months when it was turned on and displayed the problems right away. It was running fine before that. Any ideas anybody. Is it the disk or the controller card? Dave Draper ************ Phil in 88 ************** *=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=* * Dave Draper | UUCP: decvax!elrond!bu-tyng!draper * * Wang Institute of Boston University | * * 72 Tyng Road | It is impossible to make any * * Tyngsboro MA 01879 | program foolproof because fools * * 649-9731 x14 | are so ingenious! * *=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=*