Path: utzoo!utgpu!attcan!uunet!husc6!bbn!uwmcsd1!ig!agate!ucbvax!hplabs!hpda!hpdslab!hpiacla!markt
From: markt@hpiacla.HP.COM (Mark Thompson)
Newsgroups: sci.electronics
Subject: Re: Lowering power-supply impedances (Re: Homebrew audio equipment)
Message-ID: <4110007@hpiacla.HP.COM>
Date: 4 Aug 88 01:25:57 GMT
References: <1075@gethen.UUCP>
Organization: Hewlett Packard
Lines: 15

After reading all these recommendations I am suprised that no one recommended
any of the designs in The Audio Amateur.  This construction oriented audiophile
magazine has had lots of amplifier designs published in it with may different
design philologies.   The last issue had an article on how to build a 40w
mosfet amp that compared very favorably to the Rodger Mogeski RM9 tube power
amp.  In the past they have had a 25w class A mosfet, 100w mosfet, 60w mos
many biopolar designs and many mods to current amplifiers.  Its definitely
worth checking out.
You can contact them by calling (603) 924-6526 or (603) 924-6371.  I don't have
the address here.

My only tip is to resist what science would tell you about passive components
and use polyproplyne and polystryene where ever possible, they are worth the
money.

Mark