Path: utzoo!utgpu!water!watmath!clyde!att!rutgers!rochester!pt.cs.cmu.edu!cadre!pitt!cisunx!bdjst
From: bdjst@cisunx.UUCP (Ratso)
Newsgroups: comp.sys.amiga
Subject: another cmi board question
Message-ID: <12528@cisunx.UUCP>
Date: 14 Sep 88 18:24:25 GMT
Reply-To: bdjst@cisunx.UUCP (Ratso)
Organization: Univ. of Pittsburgh, Comp & Info Sys
Lines: 11

Well, anther question about the CMI accelerator.  Hw does it work with genlocks?
I am asking because I was under the impression that the 7.19 (or whatever) Mhz
rate was important for NTSC compatability.  I would like to use the board for
animation work, especially to speed up and smooth playanim.  So the switch to
make it 7.19 to tape would defeat one of my major reasns for buying the board.

Thanks for any replies.


Ben Jacobs
University of Pittsburgh