Path: utzoo!attcan!uunet!lll-winken!lll-tis!mordor!joyce!ames!mailrus!tut.cis.ohio-state.edu!rutgers!bellcore!tness7!ninja!cpe!neese
From: neese@cpe.UUCP
Newsgroups: comp.unix.xenix
Subject: Re: Xenix SCSI Drivers
Message-ID: <6800033@cpe>
Date: 12 Sep 88 14:05:00 GMT
References: <115@ttsi.UUCP>
Lines: 23
Nf-ID: #R:ttsi.UUCP:115:cpe:6800033:000:859
Nf-From: cpe.UUCP!neese    Sep 12 09:05:00 1988


>Netlanders:
>
>Is anyone using a SCSI interface with SCO Xenix ? If you've had 
>any luck setting up a 386 system with a SCSI controller for a
>hard disk you're input would be very valuable.
>
>The system is an 386 AT ( Everex Step 386 ) with an Adaptec SCSI
>controller and a Maxstor 150MB drive.
>
>Thanks in advance.


I don't know what Adaptec SCSI adapter you are using, but if you are using
the Adaptec AHA-1540 PC-AT Adapter, then you only need to get the SCO V2.2.4
from Tandy.  It supports the AHA-1540.
The system 'cpe' is using this adapter, which is Tandy part number 25-4161 
(299.00) and has been nothing short of outstanding.  BTW, 2.2.4 will also
support ST-506 stuff as well as the SCSI stuff.  I think you will be amazed
by the overall system performance.

					Roy Neese
					Tandy Computer Product Engineering
					killer!ninja!cpe!neese