Xref: utzoo comp.dcom.modems:2562 comp.dcom.lans:1887
Path: utzoo!attcan!uunet!husc6!bloom-beacon!tut.cis.ohio-state.edu!mailrus!ames!pasteur!helios.ee.lbl.gov!nosc!humu!uhccux!cs413s07
From: cs413s07@uhccux.uhcc.hawaii.edu (Cs413s07)
Newsgroups: comp.dcom.modems,comp.dcom.lans
Subject: Problems with Multitech 224E on a Novell Network
Message-ID: <2454@uhccux.uhcc.hawaii.edu>
Date: 1 Oct 88 21:36:37 GMT
Organization: University of Hawaii
Lines: 13

At this point any assistance or expertise is very much appreciated.  I am 
having a problem with a remote terminal emulation between a standalone pc
and a Novell Network.  I am using Close-UP by Norton Lambert Corp. with
a Multitech 224E running at both ends.  The host (terminal) is set  properly
as well as the remote (support) end.  I have asserted this by using modems
other than the Multitech 224E on the other end.  Thus far non-MNP class modems
do fine when communicating with the Multitech.  Could it be an MNP problem? 
I have even gone as far as turning off the error correction, with the same 
results, a frozen keyboard right after autobauding.  In suppliment, my dip
sw. are set with 3 and 8 both flipped down.  Once again, any advice is welcome.

Von Kenric Kaneshiro
Honolulu, Hawaii