Path: utzoo!utgpu!water!watmath!clyde!att!osu-cis!tut.cis.ohio-state.edu!rutgers!apple!bionet!agate!ucbvax!wnre.aecl.CDN!delaney
From: delaney@wnre.aecl.CDN
Newsgroups: comp.sys.apple
Subject: Re: GS Laser driver
Message-ID: <2325*delaney@wnre.aecl.cdn>
Date: 6 Oct 88 01:38:00 GMT
References: <18292@apple.Apple.COM>
Sender: daemon@ucbvax.BERKELEY.EDU
Organization: The Internet
Lines: 17

>Does anyone know of a way to print a Laser printer output to a disk file.  I

>>you can use the same trick that is used on the Macintosh to capture the
>>Postscript commands into a text file. By holding down CMD-F after clicking
>>OK in the '# of pages' dialog box, the Postscript commands will be redirected 
>>to a file in the System Folder called GS.POSTSCRIPT.

ALMOST RIGHT the file is in:
/DISKNAME/SYSTEM/DRIVERS/POSTSCRIPT.GS

This only works for SYSTEM DISK 3.2 and Higher

A suggestion to all be sure to have lots of space on your disk 1/2 page of text
took 19.5K 39 Block of disk space.  But it does work and very well.  Thanks 
KIETH and all the developers at APPLE for continuing to expand our support!

Grant