Path: utzoo!attcan!uunet!husc6!bbn!rochester!ritcv!cci632!ph
From: ph@cci632.UUCP (Pete Hoch)
Newsgroups: comp.sys.mac.programmer
Subject: Program fails when printing under system 3.2
Keywords: PrOpen, Sys 3.2, Crash
Message-ID: <19258@cci632.UUCP>
Date: 6 Oct 88 15:49:52 GMT
Organization: CCI, Communications Systems Division, Rochester, NY
Lines: 17

I am having a problem printing when my program is run under
an older system version.  Basicly printing works in my 
program unless I am running under system 3.2.  I have not
tried any earlier systems because I don't have any.  
However there are no problems in printing under systems
4.1 and up.  The crash is always the same.  When the
program gets to calling PrOpen I either get system error
3 or 11.  Both of these indicate a bad call to the proccessor
so I am assuming that the PrOpen call is not available, but
I can't figure out why.  There is no PrInit call.  

So please is there some anchient art of printing that has been
lost because it is not needed with the new system releases?

Thanks for any help,
Pete Hoch  -  ...!rutgers!rochester!cci632!ph
	      or   ...!uunet!ccicpg!cci632!ph