Path: utzoo!utgpu!water!watmath!clyde!att!oucsace!oucs!wright!cnee From: cnee@wright.EDU (Cheng-Lee Nee) Newsgroups: comp.unix.xenix Subject: Re: Help: Hard disk initialization and XENIX Message-ID: <313@thor.wright.EDU> Date: 2 Oct 88 00:28:18 GMT References: <728@auvax.UUCP> Organization: Wright State University, Dayton OH, 45435 Lines: 30 in article <728@auvax.UUCP>, louis@auvax.UUCP (Louis Schmittroth) says: > > In article <299@thor.wright.EDU>, cnee@wright.EDU (Cheng-Lee Nee) writes: > # the menu for modifying disk parameters disappear forever! > > Holy Toledo, I find myself in the same spot, only with a Priam > ID-45-D2, and a Tele-386 with it's own controller. I can format the > drive with the Priam utilities, and I can partition it for DOS using > the Priam software, but when I try to bring up Xenix from the N1 > diskette, I get to where I should have the menu for modifying > drive parameters, and nothing comes up, although the cursor is > responding to the keyboard. I don't have a working Xenix to use > either. What's going on here? > After several days working on this, I finally got the XENIX installed. It can boot from the hard disk now. How do I made it? Well, the disk parameters menu is still not comming up (I think something were wrote back to the N1 or N2), but I use the Norton Utility to modify the hard disk parameter table on the first sector of the hard disk right after installed the Basic System Utilities (B1 - B3). Of course, at first, I did the low-level formating according to the spec. of my disk and copy down the correct disk parameter table. So, after the XENIX changes the table according to the parameters in ROM. I just change it back and it works! +--------------------------------------------------------------+ | /\ / Cheng-Lee Nee Home phone: | | / \ / 208 B South Huron Ct. 513-878-9400 | | / \/ Fairborn, OH 45324 | +--------------------------------------------------------------+