Path: utzoo!yunexus!geac!syntron!jtsv16!uunet!seismo!sundc!pitstop!sun!decwrl!labrea!rutgers!tut.cis.ohio-state.edu!cwjcc!lim@cwlim.CWRU.EDU
From: lim@cwlim.CWRU.EDU (Hock-Koon Lim)
Newsgroups: comp.protocols.tcp-ip.ibmpc
Subject: NCSA_Telnet 2.2 crash the system on Novell Network.
Message-ID: <213@cwjcc.CWRU.Edu>
Date: 26 Oct 88 14:13:39 GMT
Article-I.D.: cwjcc.213
Sender: news@cwjcc.CWRU.Edu
Reply-To: lim@cwlim.CWRU.EDU (Hock-Koon Lim)
Organization: Case Western Reserve University
Lines: 18


 Hi,
   I have just installed the NCSA_Telnet 2.2 on my IBM PS2/50 with 3Com
   3C523 MC card.  I have to said it is a wonderful software and I like
   it very much.  However, I have run into some problems when I set my
   PC as a workstation on the  Novell network.  I can start telnet and 
   login to other unix host on the campus network. When I try to 
   close the connection by using Alt-x key, NCSA_Telnet respone with a
   message:  Attempting to close . . .  and the PC will halt with the
   system message of     Internal stack overflow
                         System halt

   I have to power off the PC in order to rebot it.  The problem  will not
   occur if my pc is not boot up as a Novell workstation.  Is someone out
   there have experience with this kind of problem?  
Hock Koon Lim, A. R. Jennings Computing Center	           
Case Western Reserve University; Cleveland, Ohio, USA  44106   
(216) 368-2982        lim@cwlim.cwru.edu