Path: utzoo!utgpu!water!watmath!clyde!att!pacbell!amdahl!acs From: acs@amdahl.uts.amdahl.com (Tony Sumrall) Newsgroups: comp.sys.amiga Subject: Re: VT100 2.x wish list Message-ID: Date: 18 Oct 88 07:50:28 GMT References: <4XHGpTy00VsfA0UVEI@andrew.cmu.edu> <2692@ingr.UUCP> Reply-To: acs@amdahl.uts.amdahl.com (Tony Sumrall) Distribution: na Organization: Amdahl Corporation, Sunnyvale CA Lines: 23 In article <2692@ingr.UUCP> jones@ingr.UUCP (Mark Jones) writes: >How about a full blown kermit, complete with kermit commands, server >mode, etc... So that files could be sent to the Amiga rather than just >received.(With the Amiga left unattended!) A possibility but not a probability as I want VT100 to remain relatively small. The new release (2.9 -- not due to be out for a while yet) will have a REAL kermit transfer module authored by Steve Walton and taken from (I hope I have this correct) Frank DaCruz's Kermit book. If all of the pieces are there and the additional code isn't too large then you can depend on it being in some later release. You realize, of course, that there *is* a C-Kermit implementation for the Amiga that does this now, right? >Mark Jones -- Tony Sumrall acs@amdahl.uts.amdahl.com <=> amdahl!acs [ Opinions expressed herein are the author's and should not be construed to reflect the views of Amdahl Corp. ]