Path: utzoo!utgpu!water!watmath!clyde!att!osu-cis!tut.cis.ohio-state.edu!cs.utexas.edu!husc6!bbn!spdcc!rayssd!raybed2!lah
From: lah@raybed2.UUCP (LANCE HOLMES)
Newsgroups: comp.sys.amiga
Subject: Diskcopy to RAD: v1.3
Keywords: RAD: v1.3
Message-ID: <1231@raybed2.UUCP>
Date: 21 Oct 88 12:32:21 GMT
Organization: Raytheon Co., Bedford, Mass.
Lines: 23


I have been experimenting with the new 1.3 workbench and having a 2000
with a micron board I also have tried using the Rad: setup as shown
in the manual.  I tried using the diskcopy as show:
                "sys:system/diskcopy df0: to rad:"
and found that it didn't work

I noticed that the manual doesn't really talk about diskcopy in the
section which talks about the programs located in the systems draw.

(guessing at the answer):

do I need the 1.3 kickstart rom in my 2000 in order for the diskcopy to
work.  Presently I use the readkwik routine which I think I will still 
prefer because I can save a little more than 880k on a disk.
I realize that autoboot won't work.

Also after reading some previous posted messages if you have a hard 
disk drive and have the 1.3 kickstart are you forced to choose between
autoboot of the hard drive or ffs. but not both.


Lance Holmes