Path: utzoo!utgpu!water!watmath!clyde!att!osu-cis!tut.cis.ohio-state.edu!mailrus!nrl-cmf!cmcl2!rutgers!cbmvax!daveb
From: daveb@cbmvax.UUCP (Dave Berezowski)
Newsgroups: comp.sys.amiga
Subject: Re: Printer density in 1.3
Keywords: print density, 1.3
Message-ID: <5079@cbmvax.UUCP>
Date: 24 Oct 88 15:08:54 GMT
References: <4009@enea.se>
Reply-To: daveb@cbmvax.UUCP (Dave Berezowski)
Organization: Commodore Technology, West Chester, PA
Lines: 16

In article <4009@enea.se> tope@enea.se (Tommy Petersson) writes:
>Could someone please tell which print densitys will be
>supported in 1.3 ? I have a Seikosha SL80AI to which I
>can get a ROM upgrade for higher density, and I want to
>know if I have any use for the new ROM's.
>
	The printer densities supported under V1.3 are a function of the
printer specific printer driver.  Although there is provision for 7
separate printer densities, not all printers have that many.  The V1.3
drivers shipped on the Extras disk support all the densities
(above 80 x dpi) of the printers they support.  The correlation between
the density setting and the specific density is noted in the printer
section of the V1.3 Enhancer manual.

	I am not familar with the Seikosha_SL80AI, so I don't know if
any of the supplied drivers will work with it.