Path: utzoo!yunexus!geac!syntron!jtsv16!uunet!cbmvax!bill From: bill@cbmvax.UUCP (Bill Koester CATS) Newsgroups: comp.sys.amiga.tech Subject: Re: Janus Problems, Help! Message-ID: <5095@cbmvax.UUCP> Date: 25 Oct 88 15:09:28 GMT Article-I.D.: cbmvax.5095 References: <58127RAN101@PSUVM> Reply-To: bill@cbmvax.UUCP (Bill Koester CATS) Organization: Commodore Technology, West Chester, PA Lines: 31 In article <58127RAN101@PSUVM> RAN101@PSUVM.BITNET writes: >I've got an Amiga 2000 and a bridgecard along with 3MB Ram and a Hard disk >The problem is, I can't get the Bridgecard to access virtual drives or convert >files using AREAD/AWRITE between systems. I've got the device=jdisk.sys in my >config file, and have the jdisk.sys and jlink.exe files on my boot disk. >I'm only trying to access the virtual drives while the PCDisk program is runnin >g. whenever i invoke the jlink,aread, or awrite commands, the pc side of the >system freezes and cannot be warm-booted. the only way to get back into the pc >side of the system is to reboot the entire system. > Sounds like the PC handler code is not getting loaded. Opwn the pcwindows display and reboot the PC. You should see a message: Janus Handler Found at Segemnt xxxx If you do not see this message use PCPrefs to set the memory window to D000 for an AT or E000 for an XT or sidecar, save the settings and reboot the amiga. If you still don't see the message make sure the file pc.boot is in the sys:sidecar directory. -- =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-= Bill Koester (CATS) >>Commodore Amiga Technical Support<< Commodore International Ltd. UUCP {allegra|burdvax|rutgers|ihnp4}!cbmvax!bill PHONE (215) 431-9355 =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-= The official word, is NO. I am therefore going anyway! Kirk - Star Trek IV Pleese desrigard eny spealing airors!!!!!!! =-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=