Path: utzoo!utgpu!water!watmath!clyde!att!osu-cis!tut.cis.ohio-state.edu!ukma!nrl-cmf!ames!amdahl!pacbell!ski!dr
From: dr@ski.UUCP (David Robins)
Newsgroups: comp.sys.ibm.pc
Subject: BASIC run but not LIST?
Keywords: GWBASIC, run-only
Message-ID: <2687@ski.UUCP>
Date: 13 Oct 88 17:30:46 GMT
Organization: Smith-Kettlewell Eye Research Institute, San Francisco, CA
Lines: 14

I have a C. ITOH factory setup program for their C315 series printers
to align the head, which runs under BASIC.  I am able to RUN it under
IBM BASICA, as well as GWBASIC.  I can LOAD it, but when I try to LIST
it, it gives an error message.  It there some way that Microsoft BASIC 
programs can be made un-LIST-able?.  How can I undo it, so I can read it? 

Please e-mail the responses; our netnews expires each day, so I might
miss it.  Thanks.
					-dave
-- 
David Robins, M.D.  (ophthalmologist / electronics engineer)
Smith-Kettlewell Eye Research Institute, 2232 Webster St, San Francisco CA 94115
415/561-1705 (voice)     {ucbvax, }\!pacbell!ski!dr
The opinions expressed herein do not reflect the opinion of the Institute!