Path: utzoo!utgpu!water!watmath!clyde!att!osu-cis!tut.cis.ohio-state.edu!mailrus!ames!pasteur!agate!labrea!decwrl!pyramid!prls!philabs!ttidca!pinn
From: pinn@ttidca.TTI.COM (Fred Pinn)
Newsgroups: comp.sys.ibm.pc
Subject: Disk & Controller question.
Message-ID: <3307@ttidca.TTI.COM>
Date: 17 Oct 88 23:41:46 GMT
Reply-To: pinn@ttidca.tti.com (Fred Pinn)
Distribution: na
Organization: Citicorp/TTI, Santa Monica
Lines: 19


    I have just purchased an AT-Baby mother board to go into my XT-
    Clone.  The board is a "True" AT type board, having an AT type
    slots.  My XT had an Adaptec RLL controller (full size board),
    and a Seagate ST-238R disk drive.  

    I realize that the floppy controller for my XT is not compatible,
    so I purchased a floppy AT controller.

    OK, you can see it coming, I want to use my XT drive and my 
    XT-RLL controller.  But there is more ... my XT mother board
    bit the dust before I could park the heads, and I must move it
    25 miles next week.

    Any suggestions ????

        Fred A. Pinn c/o Citicorp-TTI
        3100 Ocean Park Blvd.
	Santa Monica, CA        90405