Path: utzoo!utgpu!water!watmath!clyde!att!osu-cis!tut.cis.ohio-state.edu!mailrus!iuvax!rutgers!ucla-cs!loving
From: loving@lanai.cs.ucla.edu
Newsgroups: comp.sys.ibm.pc
Subject: ST-225 Dynamic Config Parameters
Message-ID: <17148@shemp.CS.UCLA.EDU>
Date: 24 Oct 88 23:29:26 GMT
Sender: news@CS.UCLA.EDU
Reply-To: loving@CS.UCLA.EDU (Mike Loving)
Organization: UCLA Computer Science Department
Lines: 6

Anybody got the dynamic configuration parameters for a seagate ST225 handy?
This is the #'s you use when ya go into debug and jump into the ROM code
on the controller card.  Things like starting reduced write current cylinder
. . . stuff like that.

loving@lanai.cs.ucla.edu