Path: utzoo!attcan!uunet!mcvax!hp4nl!dutrun!etstkvh
From: etstkvh@dutrun.UUCP (Karel van Houten)
Newsgroups: comp.unix.xenix
Subject: How to access auxiliary signals of Centronics port?
Message-ID: <519@dutrun.UUCP>
Date: 20 Oct 88 07:50:39 GMT
Reply-To: etstkvh@dutrun.UUCP (Karel van Houten)
Organization: Delft University of Technology, The Netherlands
Lines: 14

We have  SCO Xenix 2.2.3 (386) on an Olivetti M380 PC (80386 system),
and want to adress the printer reset signal, or read the paper-out 
signal on the Centronics parallel interface on the system board.
This would be no problem in DOS, but I would like to know how to do it
from a Xenix C program. Is there any ioctl call to control this?
I have looked in the manual, but couldn't find a hint.

Any suggestions? Please ....

-- 
Karel van Houten	       VOICE    : +31 71 434947
Prins Frederiklaan 286	       INTERNET : etstkvh@dutrun.UUCP
2263 HR Leidschendam 	       UUCP     : ..!mcvax!dutrun!etstkvh
The Netherlands                SURFnet  : DUTRUN::ETSTKVH