Xref: utzoo comp.dcom.modems:2808 comp.unix.microport:1891
Path: utzoo!utgpu!water!watmath!clyde!att!osu-cis!tut.cis.ohio-state.edu!mailrus!ames!pacbell!sactoh0!tree!stever
From: stever@tree.UUCP (Steve Rudek)
Newsgroups: comp.dcom.modems,comp.unix.microport
Subject: login problem with CCC 2400 bps internal modem and Microport V.2.4
Keywords: CCC_modem login_problem Microport_V.2.4
Message-ID: <128@tree.UUCP>
Date: 31 Oct 88 00:15:35 GMT
Organization: TREE BBS (916)-349-0385 Sacramento, Ca
Lines: 20

installed a new "CCC" brand 2400 bps internal modem (which was recommended
on the net as being low cost--only $99--and high quality).

Outgoing calls are fine.  Incoming calls either receive an initial string of
garbage or an, apparently, clean connect and "login:" prompt.  At the login
prompt you can type your account name with no problem.  However, when you
press return, rather than receiving a password prompt, you receive either
the garbage string "og%" or the equally sinster "On#8" and the line locks
up!  Most people disconnect at this point but I've found that if you just
wait for a minute or two the line will cycle around, emit a line of total
trash and, if you THEN hit return, you'll get a normal login followed by a
normal password.
 
I figure the problem likely involves the inittab or gettydef entries but there
is nothing obviously wrong with them--first 2400bps is tried then 1200.
The CCC modem has an acknowledged problem with not properly handling DTR;
it cannot, for instance, disconnect a user when they log off.  The "og%" and
"On#8" strings are so repeatable that I thought maybe someone could decrypt
them for me?)  I'll donate a brain-dead Teleray terminal (No...YOU pay
shipping:-) to the person who solves this mystery!