Path: utzoo!yunexus!geac!syntron!jtsv16!uunet!lll-winken!lll-tis!helios.ee.lbl.gov!pasteur!agate!bionet!uwmcsd1!lakesys!mikes
From: mikes@lakesys.UUCP (Mike Shawaluk)
Newsgroups: comp.sys.amiga
Subject: Re: Diskcopy to RAD: v1.3
Keywords: RAD: v1.3
Message-ID: <1138@lakesys.UUCP>
Date: 27 Oct 88 17:07:24 GMT
Article-I.D.: lakesys.1138
References: <1231@raybed2.UUCP>
Reply-To: mikes@lakesys.UUCP (Mike Shawaluk)
Organization: Lake Systems - Milwaukee, WI
Lines: 23

In article <1231@raybed2.UUCP> lah@raybed2.UUCP (LANCE HOLMES) writes:
>
>I have been experimenting with the new 1.3 workbench and having a 2000
>with a micron board I also have tried using the Rad: setup as shown
>in the manual.  I tried using the diskcopy as show:
>                "sys:system/diskcopy df0: to rad:"
>and found that it didn't work
>...
>do I need the 1.3 kickstart rom in my 2000 in order for the diskcopy to
>work?
>...
>Lance Holmes

I have been able to DiskCopy from a floppy to RAD:, but the last system disk I
set up to do this was under 1.3 Gamma 3 or so.  Actually, it was a Three
Stooges boot disk (!).  Anyways, you are aware (I assume) that the RAD: mount
list information must specify it as an 80 track device.  Anyways, I've done
this on my A1000 with KickStart 1.2; I've even been able to get the
ramdrive.device to work _under_ 1.2 (AmigaDOS, that is), but since I just got
my 1.3 Enhancer today (hurray!), I'm going to re-try everything to make sure
it still works.  BTW, the DiskCopy really cranks (about 2 tracks/second)!

-- 
  - Mike Shawaluk       (...!uunet!uwmcsd1!lakesys!mikes)