Path: utzoo!yunexus!geac!syntron!jtsv16!uunet!lll-winken!lll-tis!ames!mailrus!tut.cis.ohio-state.edu!osupyr.mast.ohio-state.edu!vkr
From: vkr@osupyr.mast.ohio-state.edu (Vidhyanath K. Rao)
Newsgroups: comp.sys.amiga
Subject: Re: problems with using 1.3 FFS with Pacific Peripherals Overdrive
Message-ID: <1003@osupyr.mast.ohio-state.edu>
Date: 30 Oct 88 20:32:36 GMT
Article-I.D.: osupyr.1003
References: <41342@linus.UUCP>
Reply-To: vkr@osupyr.mast.ohio-state.edu (Vidhyanath K. Rao)
Organization: Dept of Math, Ohio St U at Newark, Newark OH 43055
Lines: 9

In article <41342@linus.UUCP> sdl@linus.UUCP (Steven D. Litvintchouk) writes:
>[...]I called Pacific Peripherals about this.  They suggested that
>FastMemFirst should not be used (the Workbench 1.3 version is
>apparently buggy), [...]
Is this true? I got my hard disk and the dealer had put 1.3 on it. [But he
didn't have the enhancer kit. So no manual. sigh] FastMemFirst was in the
startup-sequence but after mount. So I put FastMemFirst up on top. I did
a one problem rebooting while fine-tuning the startup. But with only
10 hours experience...
I would appreciate a definitive answer. BTW, I have a C.Ltd controller.
and a 500