Path: utzoo!utgpu!attcan!uunet!cbmvax!bill
From: bill@cbmvax.UUCP (Bill Koester CATS)
Newsgroups: comp.sys.amiga
Subject: Re: Sidecar Problems
Message-ID: <5191@cbmvax.UUCP>
Date: 7 Nov 88 23:01:52 GMT
References: <59690RSK100@PSUVM>
Reply-To: bill@cbmvax.UUCP (Bill Koester CATS)
Organization: Commodore Technology, West Chester, PA
Lines: 28

In article <59690RSK100@PSUVM> RSK100@PSUVM.BITNET writes:
>I have a 20 meg Plus hardcard, which works fine. The default address of the buf
>fer to the amiga is at $E000. In this location, everything is fine, but when I
>reboot the sidecar, it locks up.. Without the hard card, it reboots fine.
>
>If I change the address to $D000, the sidecar reboots fine, but the amiga inter
>face software AKA janus system won't recognize it at all. So I can't use the
>hard drive on the amiga side, unless I have the sidecar set at $E000.
>
>If someone knows what I can do to make the hard card reboot at $E000, or modify
> janus.device or whatever to work at $D000, please help me..
>
Some PC hard cards have there eproms set for addresses other than $C800. If
your hardcard is not set for $c800, try that. The sidecar should be able to workwith a memory window of d000. A memory window of A000 will not allow the 
special software such as jlink and aread/awrite to work.


-- 
=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
Bill Koester (CATS)            >>Commodore Amiga Technical Support<<
Commodore International Ltd.   UUCP {allegra|burdvax|rutgers|ihnp4}!cbmvax!bill 
		               PHONE  (215) 431-9355
=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=
The official word, is NO. I am therefore going anyway!
   						          Kirk - Star Trek IV

                Pleese desrigard eny spealing airors!!!!!!!
=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=