Path: utzoo!attcan!uunet!portal!atari!danscott
From: danscott@atari.UUCP (Dan Scott)
Newsgroups: comp.sys.atari.st
Subject: Re: CircuitMaker 2.01
Message-ID: <1220@atari.UUCP>
Date: 7 Nov 88 18:35:03 GMT
References: <7119@pasteur.Berkeley.EDU>
Organization: Atari Corp., Sunnyvale CA.
Lines: 17

in article <7119@pasteur.Berkeley.EDU>, soohoo@cory.Berkeley.EDU (Ken Soohoo) says:
> I followed the directions for installing on a hard drive, and it
> booted up just fine.  Then, when I tried File...Load... XXXX Circuit
> the circuit got loaded from disk, and displayed on the screen (for
> a brief moment) and then TWO BOMBS!

Sounds like you simply have a bad copy of that program.  Did you try
running it on any other ST?

The number I have for Iliad Software is (801) 226-3270, is that the number
you have been calling?


Dan @ Atari

<The opnions expressed are not usually that of Atari Corp. and were rented by
me for use in this message>