Xref: utzoo comp.os.os9:237 comp.sys.m6809:937
Path: utzoo!attcan!uunet!lll-winken!lll-tis!helios.ee.lbl.gov!pasteur!ames!ncar!mailrus!tut.cis.ohio-state.edu!rutgers!mcnc!houser
From: houser@mcnc.org (Kevin D. Houser )
Newsgroups: comp.os.os9,comp.sys.m6809
Subject: ATARI 1040ST, COCO3
Keywords: monitors atari coco
Message-ID: <3675@alvin.mcnc.org>
Date: 1 Nov 88 19:34:58 GMT
Organization: Microelectronics Center of NC; RTP, NC
Lines: 16

Does anyone know if it is possible to hack a cable that
will allow an ATARI 1040ST be used with a magnavox 8CM515
RGB-analog monitor? Also, how easy would it be to connect the
1040ST to a monochrome monitor ($80 type) and use the 640x400 screen
resolution?

Second, ever since I have been using my 40meg hard disk on the
coco3, I have problems with multivue locking up when I try
to take a directory. If I go back to booting off the floppy w/o
the hard disk driver, MV works just fine. I'm using the B&B hard
disk interface with /d0 and /dd as the hard disk, and BBHdisk.dr
driver.

Any suggestions?

Kevin Houser
houser@mcnc.org