Path: utzoo!utgpu!water!watmath!clyde!att!osu-cis!tut.cis.ohio-state.edu!cwjcc!hal!nic.MR.NET!shamash!nis!com50!mmm!schultz
From: schultz@mmm.UUCP (John C Schultz)
Newsgroups: comp.sys.nsc.32k
Subject: Re: ICM-332 can't talk to Adaptec tape controller
Summary: What/how did you get an ICM-332
Keywords: ICM-332
Message-ID: <1163@mmm.UUCP>
Date: 31 Oct 88 03:31:53 GMT
References: <228@flinders.cs.flinders.oz>
Reply-To: schultz@mmm.UUCP (John C Schultz)
Organization: 3M Company - ES&T; St. Paul, MN
Lines: 17

In article <228@flinders.cs.flinders.oz> trevor@flinders.cs.flinders.oz (Trevor Norman) writes:
>I can't get an ICM-332 system to talk to an Adaptec (3500?) SCSI tape
>controller, which makes it a tad hard to boot...
>
>The same tape system works just fine on ICM-32016 systems, but is a total
>loser on 332 board.

While I can't help with the original question, but what/how did you get 
and ICM-332?  I had heard that Nat'l dropped the ICM line with a
"thud".  Can I trade in my ICM-32016?  How much?

More to the original question, I use an Adaptex 4070 RLL disk
controller (Emulex tape controler - sorry) with no problems on the ICM-32016.
-- 
   john c. schultz         schultz@mmm.3m.UUCP          (612) 733-4047
           3M Center, Bldg 518-1-1, St. Paul, MN 55144-1000
  The opinions expressed herein are, as always, my own and not 3M's.