Xref: utzoo comp.os.vms:10012 comp.dcom.modems:2945
Path: utzoo!attcan!uunet!kddlab!ccut!tansei!c31293
From: c31293@tansei.cc.u-tokyo.JUNET (Kenji Rikitake)
Newsgroups: comp.os.vms,comp.dcom.modems
Subject: Re: VMS modem woes
Message-ID: <2591@tansei.cc.u-tokyo.JUNET>
Date: 14 Nov 88 01:19:21 GMT
References: <227@arnold.UUCP> <2564@tansei.cc.u-tokyo.JUNET> <232@arnold.UUCP>
Reply-To: c31293@tansei.cc.u-tokyo.JUNET (Kenji Rikitake)
Organization: TWICS Co., Tokyo, Japan
Lines: 22

>From: dave@arnold.UUCP (Dave Arnold)
>Message-ID: <232@arnold.UUCP>
>References: <227@arnold.UUCP> <2564@tansei.cc.u-tokyo.JUNET>
writes:
>No, changing TTY_DIALTYPE to 1 uses CCITT protocol spec.  Basically,
>the RING signal is used.  Check VAX/VMS I/O User's Manual Part 1.

I think this is not right. TTY_DIALTYPE bit 0 only defines
whether the VAX turns off modems immediately after the carrier lost,
or waiting for 2 seconds. Setting RING signal available is defined
by bit 1, so if you set TTY_DIALTYPE to 2, RING function will be
enabled. (Do not use it when you connect PADs; PADs will not send
RING signals)
Check VAX/VMS I/O User's Manual Part 1. :-)
And you can find some new functions in latest (Micro)VMS release notes.

-- Kenji Rikitake
-- 
Kenji Rikitake / Wada Lab., Information Engineering Course 
Univ. of. Tokyo graduate school / Phone +81 3 812 2111 ext 7411
Also assistant sysop of TWICS Co.: office +81 3 351 5977
(uucp/dasnet : Kenji%DCTWCS.DAS.NET@Sun.COM)