Path: utzoo!utgpu!watmath!clyde!att!osu-cis!tut.cis.ohio-state.edu!mailrus!cornell!rochester!udel!mmdf
From: ISCOVE%UTOROCI.BITNET@CORNELLC.CIT.CORNELL.EDU
Newsgroups: comp.sys.amiga
Subject: NEC Multisync II
Message-ID: <5565@louie.udel.EDU>
Date: 19 Nov 88 18:30:02 GMT
Sender: mmdf@udel.EDU
Lines: 23

Connecting the NEC Multisync II to Amiga 2000 was straight forward:

    Amiga pin     function     Multisync pin (P9 connector)

        3         analog R        1
        4         analog G        2
        5         analog B        3
       10         comp synch      4
       16         gnd             6
       17         gnd             7
       19         gnd             8
       20         gnd             9

A standard 25 pin connector was modified by sawing off the outer 2 pins to
allow the connector to seat properly over the 23 pin Amiga output
connector.  Note that the Amiga side seems only to use the composite synch
output.  The separate H and V synch outputs did not work.  They, and the
digital colour outputs, are presumably for use by the bridge board.

Norman Iscove
Ontario Cancer Institute
Toronto
iscove@utoroci