Path: utzoo!utgpu!watmath!clyde!att!osu-cis!tut.cis.ohio-state.edu!mailrus!uflorida!gatech!bloom-beacon!ucbvax!ALBION.BITNET!SASQUATCH
From: SASQUATCH@ALBION.BITNET
Newsgroups: comp.sys.apple
Subject: modem dialing problem
Message-ID: <8811132112.aa14091@SMOKE.BRL.MIL>
Date: 12 Nov 88 14:56:00 GMT
Sender: daemon@ucbvax.BERKELEY.EDU
Organization: The Internet
Lines: 18


I have a Datalink 2400, and according to the documentation, it is supposed
to be able to dial the * character.  I need to be able to do this to
get an outside line.  I have, however, been unable to to get the modem to
do this using either TIC 3.00, Kermit 3.85, or the on-board firmware.

Has anyone else had experience with this?

Also, if I hand dial the number, what command(s) would I have to issue
to have the modem (a Hayes compatible) pick up the line after the remote
has answered and start an originate tone?

Thanks in advance.

Kevin Lepard
Bitnet:  Sasquatch@albion.bitnet

Disclaimer:  I'll deny it all in court anyway.....