Xref: utzoo comp.sys.mac:22798 comp.sys.hp:1224
Path: utzoo!attcan!uunet!portal!cup.portal.com!Howeird
From: Howeird@cup.portal.com (Howard Gary Stateman)
Newsgroups: comp.sys.mac,comp.sys.hp
Subject: Re: Connect HP LaserJet Serial II and Hp 7550A plotter to a Mac
Message-ID: <11294@cup.portal.com>
Date: 14 Nov 88 03:19:47 GMT
References: <97@YaleVM.YCC.Yale.Edu>
Distribution: na
Organization: The Portal System (TM)
Lines: 11

All I can tell you is that both the 7550 plotter and the HP Lasetjet II
have standard RS232 ports, and will hook up to ANY RS232 standard serial
device as terminals (DTE). To translate this into English, you only need
3 wires. Pin 2 is the output from the printer/plotter, pin 3 is its input,
and pin 7 is ground. They use Xon/Xoff handshaking. Just wire the Mac's
serial output to pin 3, the Mac's serial input to pin 2, and ground to
pin 7. If the Mac in question doesn't have a simple serial port, you
are SOL. Unless you can get a black box to convert the Mac's output
to standard serial.

Good luck.