Path: utzoo!attcan!uunet!ncrlnk!ncrcae!hubcap!gatech!uflorida!mailrus!ncar!umigw!umbio!medsoft!p9.f1.n360.z1.uucp!Dan.Husk
From: Dan.Husk@p9.f1.n360.z1.uucp (Dan Husk)
Newsgroups: comp.sys.ibm.pc
Subject: Commodore printer conversion
Message-ID: <120.237AF00F@medsoft.uucp>
Date: 10 Nov 88 08:30:00 GMT
Sender: ufgate@medsoft.uucp (newsout1.18)
Organization: FidoNet node 1:360/1.9 - Augusta Forum, North Augusta SC
Lines: 19


 > From: norden@bgsuvax.UUCP (Lee Norden) Date: 8 Nov 88 15:31:48 GMT
 > Organization: Bowling Green State University B.G., Oh. Message-ID:
 > <3063@bgsuvax.UUCP> Newsgroups: comp.sys.ibm.pc
 > 
 >
 > I just picked up a Gemini 10X printer that had been hooked up to a
 > Commodore.  The serial connector is a round, 6 pin connector.  Is there
 > an easy way to convert the thing to make it run on an IBM PC?

You should be able to hook a parallel to serial convertor from your IBM
and use a COM port.
Regards, Dan Husk


--  
Dan Husk - via FidoNet node 1:135/3
Medical Software Exchange BBS (305) 325-8709
UUCP: ...uunet!gould!umbio!medsoft!360!1.9!Dan.Husk