Path: utzoo!attcan!uunet!husc6!mailrus!ukma!psuvm.bitnet!vxl103
From: VXL103@PSUVM.BITNET
Newsgroups: comp.sys.ibm.pc
Subject: I need more MEMORY!
Message-ID: <61411VXL103@PSUVM>
Date: 14 Nov 88 04:09:55 GMT
Organization: Penn State University - Center for Academic Computing
Lines: 12

What else can I say?  I'll entertain any offer or ideas for that matter on
the above subject.  Possible ideas are acquiring an AST six-pak or equivalent.
My RAM chips have been SOLDERED (gak!) in, and if I were to indeed purchase
41256-150 ns or better chips, I would have to take the whole schpiel (is it
spelled tight?) to a repair shop and have it soldered in and tested (sorry
folks, I can't go solo on this one).  Another type of board that I can
also use is a QUADRAM board.  The point is that I either need chips or
an 16 (not 8) bit memory board that can accommodate my AT&T PC6300, or I can
use the 8-bit board and seriously compromise my CPU speed.

I'll be at this address (where else?) to peruse any reasonable offer ...

Vincent Lai