Path: utzoo!attcan!uunet!yale!husc6!rice!sun-spots-request
From: ISSTTH@NUSVM.BITNET (TNG TH)
Newsgroups: comp.sys.sun
Subject: SunView again and again
Message-ID: <8811151426.AA27702@rice.edu>
Date: 23 Nov 88 11:24:29 GMT
Sender: usenet@rice.edu
Reply-To: Sun-Spots@Rice.edu
Organization: Rice University, Houston, Texas
Lines: 11
Approved: Sun-Spots@rice.edu
Original-Date: Tue, 15 Nov 88 08:49:13 SST
X-Sun-Spots-Digest: Volume 7, Issue 25, message 5 of 16

A few weeks back I posted a mail asking for help in using Sunview with
CGI, CORE, PHIGS... I received a few replys on using plain pr_rops alone
and on using CORE. pr_rops is fine but slow and not rich enough. I can't
even perform rectangle clipping. Then there were a few examples on linking
CORE with SunView. I couldn't make that work either.  What I need is the
ability to use SunView's buttons, panels, cycles, etc TOGETHER with a
graphics package without using extremely low level stuff.  I must be very
dumb 'cause I have read the CGI and CORE manuals and couldn't find out how
to do just that.  Is anyone listening? Or am I the odd ball out?  Are
there better ways? How on earth was FRAMEMAKER written in the first place?
With SunView?