Path: utzoo!attcan!uunet!peregrine!elroy!ames!mailrus!uflorida!ukma!tut.cis.ohio-state.edu!osu-cis!att!oucsace!pmech
From: pmech@oucsace.cs.OHIOU.EDU (Paul J. Mech)
Newsgroups: comp.sys.tandy
Subject: Pinout of serial port on 16b?
Keywords: 16b serial get rid of
Message-ID: <366@oucsace.cs.OHIOU.EDU>
Date: 22 Nov 88 05:46:58 GMT
Organization: Ohio University CS Dept., Athens
Lines: 14


	I replaced my old 16b with an NCR MiniTower and, true to my
experiences in dealing with Tandy in the last few years, was told by
the local service center that there was no pinout for the serial ports,
was told by the software people that the service people had it, and
was told by the salesmen that they could probably find a technical
reference that I could buy. Does anyone out there know the pinout for
the 'A' and 'B' serial ports on a 16b? I would assume that they are
the same as for the II and the 6000 (dangerous assumption, I know  ...)?
I want to transfer over the last few source from the 16b, and then, if
I can find anyone who wants it, sell it.

Thanks in advance,
pjm